The PW Conduit Wet-Wet series remote sensors are installed directly into the pipe and electrical connection is made between the PWC remote sensors and PW transmitter via 4-conductor shielded cable run through conduit. This dramatically reduces labor cost by eliminating plumbing/piping to a traditional transducer. Startup time is reduced since purging air out of the lines is not necessary. Traditional plumbed bypass assemblies are no longer required. Choose between the PW10 and PW20 model based on your anticipated PSID range.
• Run conduit and 4-conductor shielded cable from transmitter to elements to wire in the field
• Eliminates costly plumbing and by-pass manifolds
• Micro-machined silicon strain gauge sensor
• IP65 (when installed with water tight fittings)